Simple light tabs for an 05
#1
Simple light tabs for an 05
I have an 05 XLT 2wd extended cab and wanted to mount a couple of lights on the front. I found there was a bolt on the back of the bumper on each side at just about the right spot. I went to tthe hardware store and bought a strip of aluminum, 1 1/2 wide by about 1/4 thick. I made a couple of L-shaped brackets, measured and drilled two holes in each and mounted them to the bolts behind the bumper. I can see where heavier lights might require steel instead of aluminum, but my lights are not very heavy. Works real nice. I'll try and post some pics if anyone is interested.
#2
Not bad newbee.... BUT
https://www.ranger-forums.com/forum2...ght=LIGHT+TABS
https://www.ranger-forums.com/forum2...ght=LIGHT+TABS
Been done many times. But post some pics anyway.
Welcome to the site, and keep modding.
https://www.ranger-forums.com/forum2...ght=LIGHT+TABS
https://www.ranger-forums.com/forum2...ght=LIGHT+TABS
Been done many times. But post some pics anyway.
Welcome to the site, and keep modding.
Thread
Thread Starter
Forum
Replies
Last Post
annguyen1981
OLD - Interior, Exterior, Electrical, & Misc.
28
12-25-2011 06:42 PM
Sonic04Edge
General Ford Ranger Discussion
18
12-14-2005 12:42 PM