I know this is a long shot.. I have a 2010 Ranger and just received a NEW Bed extender (OEM accessory - 1L5Z-99286A40-AB). It did not come with the installation instructions and before I start, I'd really like to have them. I have a Under Rail Bed liner installed and it appears that I will have to drill or hole-saw thru it..

Anybody by chance have a copy of the instructions??

Thanks........

Foamy!!!!

 

Yes you will likely have to if it's covering the holes already in the truck bed. Can you see behind it at all? On each side at the rear of the bed there is one big hole centered between two smaller holes. You will need to drill holes in the bedliner the same size or slightly larger. Thread the two pivots/bolts that come with the extender into the big holes, snap on the bed extender, close the locking pins and you're done.

 

Thanks Fullscale,

I looked at it in the light of day and I see the 2 holes (1 above and below for the grommets), looks like the center one will self tap the Pivot bolts. Off to the store in a bit for a small Hole Saw..'

Thanks
Foamy