PAshooters Bumper Build
#1
PAshooters Bumper Build
So I finally got around to building my bumper because my original was bent from a deer hit and was rusting through.
I modeled it off of wolfman00's old bumper that is now mothman999's.
Its made from a skeleton of 1 inch square tubing thats 1/8" thick.
Here's pictures while we were still getting the skeleton built.
It was all done with a Lincoln Electric Eagle 10,000. I am lucky enough to have a pap whos a gas line welder, so his beads are very nice.
We have it mostly covered now with 10 gauge steel and after that I plan on bondoing it to make all the imperfections go out of it and then hurculining it.
I modeled it off of wolfman00's old bumper that is now mothman999's.
Its made from a skeleton of 1 inch square tubing thats 1/8" thick.
Here's pictures while we were still getting the skeleton built.
It was all done with a Lincoln Electric Eagle 10,000. I am lucky enough to have a pap whos a gas line welder, so his beads are very nice.
We have it mostly covered now with 10 gauge steel and after that I plan on bondoing it to make all the imperfections go out of it and then hurculining it.
#4
Thread
Thread Starter
Forum
Replies
Last Post