I bodylifted my truck and am wanting to put my brush guard back on but i havnt came up with a good way to mount it yet. Those of you with them how did you do or if anybody has any good ideas let me know!

 

haha im going to have the same problem if i keep the ranger. but my brush guard is all custom

 

I just havnt thought of a good way to get it down under the bumper and attach it to the frame and after adding my front hitch last weekend there not really enough room to run bolts through the frame from side to side it will probably have to be top to bottom. but then again i have to design something that works

 

i did it to mine. basically all i did was cut 3inches out and have it welded back together.

 

where and how does yours mount i cant quite tell by your picture? how do you cut 3 inches out and then it fits with a 3 inch lift?

 

well i cant find the thread/pics of when i did mine but its pretty self explanitory if you post pics of what your your brackets look like i can help you.

 

same here

 

i dont have any good pics of it right now so i will take some thursday when i get back home.

 

i just drilled new holes and mine bolted right up.

 

Ok so I got a pick of how it mounts. I think if I just cut off the part that comes up off of it and drill new holes it will be fine because that part is 3 inches tall. Is that what you guys think too?

 

i dont see any pic.

 

yea sorry i was using my phone and i couldnt figure out how to upload the pic.

Not the best pic but i think you can tell how it mounts.

 

Me and my dad were thinking weld on a peice of 1/4 plate to square up the bottom of brush guard under where the bolt holes are. then measure 3 inches down from center and drill new holes and cut the top mounting holes off. and it should bolt up and be just about in the origonal spot before the body lift.