Bent Rear Fenders
#1
Bent Rear Fenders
As the title says I bent not just one but both of my rear fenders, nothing too major. I cracked a little bit of the paint and DO NOT want it to spread, and I was also curious how I can bend them back? (Rubber martlet etc.) The bend on both sides is towards the front of the truck on the bottom half and are about a half dollar bent out.
Your feedback is very important, because I need to get this done ASAP before the chipping gets worse, I'd also like to know if there is a spray or compound I can use on it to keep the spreading of the chipping to a minimum and for it not to rust.
Thanks
Your feedback is very important, because I need to get this done ASAP before the chipping gets worse, I'd also like to know if there is a spray or compound I can use on it to keep the spreading of the chipping to a minimum and for it not to rust.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Xplo
General Ford Ranger Discussion
10
03-25-2009 05:31 PM
Tys 4x4 FTW
General Ford Ranger Discussion
5
03-04-2009 06:41 AM
bskouby
2.9L & 3.0L V6 Tech
18
08-19-2005 12:33 AM