Cab Guard, Rails & Rear Rack, project finished
#1
Cab Guard, Rails & Rear Rack, project finished
I finally finished this project. I started it a long time ago, but had to put it aside for other projects.
The Cab Guard and Rear Rack are made with 1 x 2", 11-guage tubing.
The bars in the cab Guard are 1" square and 3/4" square tubes, turned 45 degrees and the top of the bars are tipped in towards the center.
The Rails are made with 1 1/4" square tubing and are turned diamond. The bed-side covers are 1/8' x 3".
Most important is the roll-up bed cover still fits!
...Terry
The Cab Guard and Rear Rack are made with 1 x 2", 11-guage tubing.
The bars in the cab Guard are 1" square and 3/4" square tubes, turned 45 degrees and the top of the bars are tipped in towards the center.
The Rails are made with 1 1/4" square tubing and are turned diamond. The bed-side covers are 1/8' x 3".
Most important is the roll-up bed cover still fits!
...Terry
#12
He started with 20 foot long 1x2" tube, secured one end, heated short sections of the tube and bent it a little at a time while cooling one side of the tube with a wet rag. He just worked his way along the tube until it had a 1" curve over 48" length.
...Terry
Thread
Thread Starter
Forum
Replies
Last Post
RANGERDANGER17
Fabrication & Tool Tech
13
06-20-2011 02:12 AM
Bence
OLD - Interior, Exterior, Electrical, & Misc.
0
09-03-2010 06:29 PM