Built a headache rack
#1
Built a headache rack
Needed somewhere to mount my lights an I'm always hauling crap so I built this. Took it in to get sandblasted today and going to paint it silver. I also have 2 CB antenna mounts welded on but I took the pics first without thinking. 1/8" 2x2" square tube and 2x2" angle iron for the base with 1/2x2" vertical bars and welded together with my old Lincoln AC/DC welder with all 3/32" 6013 rod.
#4
#7
If you look close on the top pic (looking at it from the back) at the right piece of angle iron coming back at the bottom of that you can see a stud I welded on. There are 4 of these, 2 on each side that go through holes I drilled in the box rail and I put nuts on them to hold it down. The 2 front ones are a real ***** to get on and tight with my plastic box liner but it can be done.
Thread
Thread Starter
Forum
Replies
Last Post
Bs03fx4
OLD - Interior, Exterior, Electrical, & Misc.
15
12-14-2010 04:12 PM