Built Cj7 bumpers, Finally installed
#1
#4
#7
#11
The rear mounts are made of 3\16 angle iron, one welded to the bumper, and a piece bolted to the truck, Then those bolt together, The back mounts are going to get added to eventually, But he was in a hurry to get it on because he'd be driving it soon. Which he has more work to do on the truck, sliders, and roll bar work, so it will be done when thats done.
The part on the rear of the truck where the bumper mounts to, had some steel welded into the back of it to stiffen it up a bit.
The front crossmember had 3\16 angle iron welded into it, and angle iron again for mounts on the front.
Actually, all steel used for the mounts is 1\4"
Last edited by Ray_Welder; 07-06-2009 at 05:57 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Bs03fx4
OLD - Interior, Exterior, Electrical, & Misc.
15
12-14-2010 04:12 PM
TheBearJeweler
OLD - Interior, Exterior, Electrical, & Misc.
12
05-11-2009 12:55 PM