Truck is up and running... finally...
#1
Truck is up and running... finally...
This is my explorer 5.0 swapped Mazda B3000. Please keep in mind that we just got the truck up and running naturally aspirated. Its on the stock tune and running out of injector at higher RPMs.
Start up and rev
Drive-by
Cruise-by at 70MPH
Burnout
Start up and rev
Drive-by
Cruise-by at 70MPH
Burnout
#4
The hood doesn't fit. I got mis-matched rubber mounts from the dealer and between that and the 1" intake spacer, the IAC valve hits the hood. I have a fiberglass 2" cowl hood in the mail. Its the same one Camburg sells.
#9
Thread
Thread Starter
Forum
Replies
Last Post
msoutlaw68
Member Introductions
2
07-07-2011 11:50 AM
Duo_Z
General Ford Ranger Discussion
1
10-25-2008 01:26 PM