General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.

"milky brown" oil, clicking/ticking, water dripping... blown head gasket????

Thread Tools
 
Search this Thread
 
  #1  
Old 06-10-2011
jmshanafelt's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: renton, wa
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
"milky brown" oil, clicking/ticking, water dripping... blown head gasket????

I have a 94 4.0 v6. 165k miles. 2wd 5 spd auto.

Recently I rolled the truck on its drivers side and slid it across a highway... yes, i know, not the most intelligent thing to do.

Since then it has had a leak in the radiator. I have been filling it up constantly but have now noticed a very loud clicking/ticking noise and white smoke coming from the exhaust. water is also dripping off the rear of the cat and the front of the muffler... busted head gasket?

also i checked the oil and it was a milky brown. any one know anything?

Thanks,

John
 
  #2  
Old 06-10-2011
MAT88GT's Avatar
Member
Join Date: Feb 2011
Location: Muscatine, Iowa
Posts: 34
Likes: 0
Received 0 Likes on 0 Posts
did you drain all the fluids after rolling it?
 
  #3  
Old 06-10-2011
jmshanafelt's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: renton, wa
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
...no. father did not tell me to and hes been through this before
 
  #4  
Old 06-10-2011
MAT88GT's Avatar
Member
Join Date: Feb 2011
Location: Muscatine, Iowa
Posts: 34
Likes: 0
Received 0 Likes on 0 Posts
well...depends how long the engine ran w/o oil pressure while you were rolled over, could have done more damage than you think

its not uncommon to crack the block in a roll over or bad impact...that would definitely explain the mixing of fluids.

pressure test the cooling system, check the plugs and go from there
 
  #5  
Old 06-10-2011
jmshanafelt's Avatar
Member
Thread Starter
Join Date: Jun 2011
Location: renton, wa
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
it never rolled over completely. just on its side and slid. also, i shut it off immediately after i stopped sliding, less than aminute after the "roll"

is there any way to check after i pulled the intakes off?
 
  #6  
Old 06-11-2011
mossyoak03's Avatar
Member
iTrader: (1)
Join Date: Oct 2006
Location: Virginia Beach, VA
Posts: 193
Likes: 0
Received 0 Likes on 0 Posts
the water coming out of your exhaust and white smoke is a sign of both head gaskets blown.

the ticking is not good. water has probably already reached your pistions. i wouldn't give it much longer
 
  #7  
Old 06-11-2011
StxDangerRanger's Avatar
RF Veteran
iTrader: (2)
Join Date: Dec 2010
Location: Michigan
Posts: 6,315
Likes: 0
Received 6 Likes on 6 Posts
Originally Posted by mossyoak03
the water coming out of your exhaust and white smoke is a sign of both head gaskets blown.

the ticking is not good. water has probably already reached your pistions. i wouldn't give it much longer
This.
you for sure blew the gasket on whichever side was "up" when you were sliding. the other side may not be blown, but its forsure on its way out.
the milky brown oil is antifreeze mixing in with your oil, which is a sign of no gasket, the white smoke is antifreeze burning off because of said head gasket.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Redneck Ranger
4.0L OHV & SOHC V6 Tech
41
06-22-2012 06:32 PM
filmnerd891
General Ford Ranger Discussion
6
06-27-2011 07:08 PM
filmnerd891
General Technical & Electrical
4
06-27-2011 06:24 AM
rangerrob
2.9L & 3.0L V6 Tech
1
02-20-2006 01:23 PM
rangeon99
4.0L OHV & SOHC V6 Tech
20
12-04-2005 01:36 PM



Quick Reply: "milky brown" oil, clicking/ticking, water dripping... blown head gasket????



All times are GMT -6. The time now is 06:55 PM.