I noticed my pass side rear flare was hanging off from the front bottom, also the support bar that runs to the frame was bent a little, now my flare wont line up to the body, right at the body line about 2 holes up it sticks out a 1/4" or more. If i press in on it, it will line up but i think the clip in the flare is messed up and not holding like it should, i have searched all over. Is there somewhere online i can buy these? I dont ever recall slamming down on something hard and im not sure if my wheels and tires rubbed but it doesnt look like it. Im planning on painting them so id like to get more clips and those 1 time use push pin crap before i take them off. Any ideas?

 

probably Ford, but any 01-03 flare clip should work, not just Level II specific ones. FX4, Edge, and 01 XLT Offroads)

 

I was hoping rock auto or somewhere would have them but i cant find any, do the clips press into the flare or what?

 

That Im not sure about as I dont have flares, I just knew all the flares are the same. From my understanding, they are just plastic pins that pin into holes in the fender

 

the flares have a lil c-notch in them that the clip slides and locks into

 

I got mine from a local body shop. Like $0.45 each.

 

Ford Rocker Panel Ground Effects Moulding Clip

 

Awesome thanks man!