CB / Ham Antenna mounts
 

Hello been in contact with Jerry Breedlove a Ham
he's going to have a new antenna mount for the ford
ranger very soon https://breedlovemounts.com/
See this EZN 4 degree bracket this is a stake pocket
mount but it has a 4% so antenna will sit upright.
Last time i talked he says it be out end of this week.:ford:

The stuff looks good, the Ball Mount is impressive.
I have book marked his site, thanks.

Remember to add a ground strap (⅝” or larger braided strap) to the mount or at least the bed to frame and don’t forget the infamous bare metal thing.

Mounts
 

He has a nice line of antenna mounts and they hold about any thing you
but on them check out http://www.youtube.com/watch?v=2IiXKPrMjGA:popcorn:

Jerrys cool !
 

Hello i been talking to jerry by e-mail
and he's going to send me a few of the
mounts he's made up from the info i'd
sent him to test for fit and i don't pay
a thing kinda like a beta tester!:smile:

Grounding
 

ground straps yes i use 6 on bed 4 on cab
2 on hood over kill yes but RF ground and DC
are like night and day.O i found only one very
small ground for cab on pas.side? I also add
one to the frame to engine and batt.:squareeye

If you are into communications and want to eliminate a lot of the static that comes in through the system, you can add grounds straps to everything movable, I.e. doors to body, tail gate to body, hood to body, he's even the plastic ones. Brd straps and cab straps are a must too as you said.
Also, the antenna mounts and the radio chassis along with the blk power wire that should go to the battery with the red one.

I use 3/8" braided straps added to all of the above places, does it help, not really sure but I talk a lot on the HAM Radio without any problems but that ins FM not AM.

Luck on your project.

Tire noise
 

Had a Kia that had a problem with Tire noise !
Funny part only on bridges? Never did rid myself
of that but got rid of that car too.:biggthump

Not sure ground straps will help with tire noise or bridge grating but who know.

Enjoy your radio and communications.

Tire noise is very hard to stop from what i have seen on line.
But i only had one car that had it. It's a shame radioshack don't
sale the filters they used to have all you can find any more is
snap on toroids in small parts. They need a name change

The Rat Shaq was never any good, except for small parts, as far as I am concerned; another story.

Funny on the tire noise, sometimes sipping the tread ! lol.

You can find anything Rat Shaq had/has on line, there are always helpful sites, some for just CB use or HAM Sites.
If they went away it would be no loss.

Ltr

Mount installed
 

Hello here is the new pocket mount.I like it not hard to install also.
It is a SO 239 mount with aDIA3824 Adapter you can also get just a 3/8 24 mount.
http://www.diamondantenna.net/dia3824.html


https://www.ranger-forums.com/attach...ine=1355081857

https://www.ranger-forums.com/attach...ine=1355081857



https://www.ranger-forums.com/attach...ine=1355081857

mount
 

Few more shots
http://i1359.photobucket.com/albums/...h_DSCN0159.jpg

http://i1359.photobucket.com/albums/...h_DSCN0161.jpg