CB / Ham Antenna mounts
#1
CB / Ham Antenna mounts
Hello been in contact with Jerry Breedlove a Ham
he's going to have a new antenna mount for the ford
ranger very soon https://breedlovemounts.com/
See this EZN 4 degree bracket this is a stake pocket
mount but it has a 4% so antenna will sit upright.
Last time i talked he says it be out end of this week.
he's going to have a new antenna mount for the ford
ranger very soon https://breedlovemounts.com/
See this EZN 4 degree bracket this is a stake pocket
mount but it has a 4% so antenna will sit upright.
Last time i talked he says it be out end of this week.
#3
Mounts
He has a nice line of antenna mounts and they hold about any thing you
but on them check out http://www.youtube.com/watch?v=2IiXKPrMjGA
but on them check out http://www.youtube.com/watch?v=2IiXKPrMjGA
#4
#5
#6
Old Guy User…
iTrader: (12)
Also, the antenna mounts and the radio chassis along with the blk power wire that should go to the battery with the red one.
I use 3/8" braided straps added to all of the above places, does it help, not really sure but I talk a lot on the HAM Radio without any problems but that ins FM not AM.
Luck on your project.
#9
#10
Old Guy User…
iTrader: (12)
The Rat Shaq was never any good, except for small parts, as far as I am concerned; another story.
Funny on the tire noise, sometimes sipping the tread ! lol.
You can find anything Rat Shaq had/has on line, there are always helpful sites, some for just CB use or HAM Sites.
If they went away it would be no loss.
Ltr
Funny on the tire noise, sometimes sipping the tread ! lol.
You can find anything Rat Shaq had/has on line, there are always helpful sites, some for just CB use or HAM Sites.
If they went away it would be no loss.
Ltr
#11
Mount installed
Hello here is the new pocket mount.I like it not hard to install also.
It is a SO 239 mount with aDIA3824 Adapter you can also get just a 3/8 24 mount.
http://www.diamondantenna.net/dia3824.html
It is a SO 239 mount with aDIA3824 Adapter you can also get just a 3/8 24 mount.
http://www.diamondantenna.net/dia3824.html
Last edited by al lafon; 12-09-2012 at 12:45 PM.
#12
mount
Few more shots
http://i1359.photobucket.com/albums/...h_DSCN0159.jpg
http://i1359.photobucket.com/albums/...h_DSCN0161.jpg
http://i1359.photobucket.com/albums/...h_DSCN0159.jpg
http://i1359.photobucket.com/albums/...h_DSCN0161.jpg
Last edited by al lafon; 12-09-2012 at 01:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Want to Trade: Back Rack Tool Box Mounts for Mounts w/o Tool Box
Scrambler82
OLD - Interior, Exterior, Electrical, & Misc.
7
05-07-2010 05:27 PM