need a little help
#1
Join Date: Nov 2008
Location: Newark, Delaware
Posts: 1,751
Likes: 0
Received 0 Likes
on
0 Posts
need a little help
This first pic is driverside... idk what that line is but it never leaked before
Second pic and third pic are of the tie rods with were replaced 3 months ago and now there is grease laying on the botton control arm.
Driver side tie rod
Under shot or tie rod on pass side
And the last one is oil leaking from the crank shaft, NONE of these leaks were ever here before.
Any input would be great, i still have the warrenty so i may take it in and have the dealer look at it. Thanks
Second pic and third pic are of the tie rods with were replaced 3 months ago and now there is grease laying on the botton control arm.
Driver side tie rod
Under shot or tie rod on pass side
And the last one is oil leaking from the crank shaft, NONE of these leaks were ever here before.
Any input would be great, i still have the warrenty so i may take it in and have the dealer look at it. Thanks
#2
That line looks like the diff breather vent, but I could be wrong. It also looks like oil, which seems odd, because I don't recollect anything above there that would be leaking oil.
And leaks are never there when you expect them. That's why they are called leaks.
From the crank shaft, is that the front main seal? I don't remember. Obviously there is some seal or gasket that has gone bad that needs replacing.
And leaks are never there when you expect them. That's why they are called leaks.
From the crank shaft, is that the front main seal? I don't remember. Obviously there is some seal or gasket that has gone bad that needs replacing.
Thread
Thread Starter
Forum
Replies
Last Post
Crein2009
General Ford Ranger Discussion
6
05-24-2009 10:42 PM
Fx4wannabe01
Suspension Tech
17
01-28-2008 07:08 AM