So ive got death wobble but only on right turns, i had it aligned today. I started noticing it after i disassembled the drivers side suspension (to replace the dam motor mount) i completely took it apart, took the tie rod out of the knuckle, took out the coil spring....everything. And once i put it all back together i started noticing it. Any ideas?
It doesnt make sense to me that if we took apart the drivers side suspension why it would wobble on only right turns.

 

bump.

 

sorry to hear that. of i was you i would take it all back apart then put it all back together again. its some work, but hey. goodluck i would probably try to drive as little as possible until you get this fixed

 

No clue man.

 

Not to be THAT guy, but did you assemble everyything back together correctly?

 

Is your rotor also your hub? Meaning are the wheel studs built into the rotor?

If so, did you put the cotter pin back in after putting the nut back on the spindle? If not the bearing could be moving out far enough to cause this.

Just an idea.

 

check your ebrake ... mine was sticking when i first bought the truck and doing this on right turns lol ...