Billet installed- curios...
#1
Billet installed- curios...
Hey guys I bought my billet grills from ebay and installed it on my truck, but it is recessed back from the plastic shroud that the original "honeycomb" is mounted.
Is this normal, or did they send the wrong one do you think? the packages say its the right one.
ill get a pic of it when I get back home
Thanks!
Is this normal, or did they send the wrong one do you think? the packages say its the right one.
ill get a pic of it when I get back home
Thanks!
#4
http://cgi.ebay.com/ebaymotors/ws/eB...59,p2759.l1259
Doesnt that look curved? I didnt think it was flat, but im trying to get a PH# to call these ppl
Doesnt that look curved? I didnt think it was flat, but im trying to get a PH# to call these ppl
#6
I know my t-rex grille has 4 vertical bars behind the horizontal bars, at the bottom of the 4 vertical bars there is a hold in each bar that you drill holes in the plastic surround and put a rivot through.... you can fix the side edges though, where the horizontalbars arent flush against the surround. I just took the grill and put it on my leg and pressed down on the sides so it would "curve" the grille more and it will fit flush on the sides of your surround.
#7
Member
iTrader: (1)
Join Date: Nov 2007
Location: Vacaville, CA
Posts: 1,100
Likes: 0
Received 0 Likes
on
0 Posts
are you sure the grill surround is clipped all the way in?? you could put a couple washers between the grill mounts and frame thats what i did with my carriage works one but mine wassnt that big of a gap oh and you should cut the little tabs off the surround that may also be the cause of the gap
#8
http://cgi.ebay.com/ebaymotors/ws/eB...59,p2759.l1259
Doesnt that look curved? I didnt think it was flat, but im trying to get a PH# to call these ppl
Doesnt that look curved? I didnt think it was flat, but im trying to get a PH# to call these ppl
Thread
Thread Starter
Forum
Replies
Last Post
01xltranger4x4
OLD - Interior, Exterior, Electrical, & Misc.
62
07-01-2010 10:42 AM