Wood Stakes for Ranger
#1
Wood Stakes for Ranger
I need to make wood side rails for the back of my 2008 Ranger to haul a bunch of stuff in boxes (no illegals) . I think I saw somewhere a metal piece that fits the stake holes and you just have to attach the wood. Anyone know where these are sold or should I just make it out of wood?
Lou
Lou
#5
I'd just make 'em. I made these for my buddy's truck.....just kinda made stuff fit. Never made a back door for it though, but it did the job....
CRAP! I don't have pictures of histruck with them installed. I just used like trimmed down 2x2's in the stake holes, then some 1x6's or 2x6's going between the two stakes. yes they shook a little bit, you could make a crossmember on the front, and hinge and pin a rear gate to eliminate that shaking.
CRAP! I don't have pictures of histruck with them installed. I just used like trimmed down 2x2's in the stake holes, then some 1x6's or 2x6's going between the two stakes. yes they shook a little bit, you could make a crossmember on the front, and hinge and pin a rear gate to eliminate that shaking.
#6
Thread
Thread Starter
Forum
Replies
Last Post
FMD
General Ford Ranger Discussion
1
11-11-2007 01:21 PM