HELP, TRANS STUCK IN GEAR
#1
HELP, TRANS STUCK IN GEAR
well i was trying to install my hurst shifter and im guessing that maybe it got knocked into gear before i took out the stock shifter stub?
either way, im F**KED cuz now my trucks stuck in either 2nd or 3rd and i cant do anything about it.....
trying to moove the shifter around it feels in neutral, but i cant get the shifter into any other gear at all....but when i start up the truck, its already in gear...
HELP PLEASE. i dont know what to do and its too late to try hurst's customer service or even trying any shop....
either way, im F**KED cuz now my trucks stuck in either 2nd or 3rd and i cant do anything about it.....
trying to moove the shifter around it feels in neutral, but i cant get the shifter into any other gear at all....but when i start up the truck, its already in gear...
HELP PLEASE. i dont know what to do and its too late to try hurst's customer service or even trying any shop....
#2
The following users liked this post:
93greenmachine (02-24-2020)
#4
just found this pic on rps
It is a pic a guy took while installing his hurst and it is what should look like in neutral. Heres the link
My Hurst Intall write up/Tutorial: 29 pics so 56k watch out!!! - Ranger Power Sports Forum
It is a pic a guy took while installing his hurst and it is what should look like in neutral. Heres the link
My Hurst Intall write up/Tutorial: 29 pics so 56k watch out!!! - Ranger Power Sports Forum
#6
Howdy
haha... been there done that.
Remove the shifter look down into the trans you will see you will see 2 rows of (i dont know what to call them but i'll call them teeth). Use a screwdriver and realign the top and bottom row of teeth put the shifter back on and you should be good to go.
Remove the shifter look down into the trans you will see you will see 2 rows of (i dont know what to call them but i'll call them teeth). Use a screwdriver and realign the top and bottom row of teeth put the shifter back on and you should be good to go.
ok my slave cylinder went out, fixed that but now its stuck in gear i did what you said and its still in gear the only gear that it dont pull forward is reverse.
anything helps.
If its
#7
I just joined ,I was stuck in first gear, I googled it and you guys showed up . I did what you said to do and it saved my ***. I had pulled it apart to replace the slave and clutch . When I put it together it was stuck and would not shift tried what you said and it saved my day.
Thank you !!!
Thank you !!!
The following 2 users liked this post by rodtoo40:
94CaymanBlueLongBed (10-03-2023),
FMD (10-04-2023)
Thread
Thread Starter
Forum
Replies
Last Post