rear wheel to, 4 wheel ?
#1
rear wheel to, 4 wheel ?
So this is the detailed question
Iv got a 1991 Ford Ranger, 4x4 i would like to take the 4x4 component and put it on my
1987 Ford Ranger EXT Cab rear wheel drive, both trucks are manual
if you guys have seen any guides or talks about doing this sort of thing please give me a hand :) thanks !
Ps. If more info is needed just post here and ill get back to you :)
THANKS RANGER FORUMS !!!!!!!! YOU GUYS ARE AWESOME !
Iv got a 1991 Ford Ranger, 4x4 i would like to take the 4x4 component and put it on my
1987 Ford Ranger EXT Cab rear wheel drive, both trucks are manual
if you guys have seen any guides or talks about doing this sort of thing please give me a hand :) thanks !
Ps. If more info is needed just post here and ill get back to you :)
THANKS RANGER FORUMS !!!!!!!! YOU GUYS ARE AWESOME !
#2
Well if it's electronic 4x4 get ready to do some wiring. If not you just need to cut a hole in the floor for the manual T-case shifter. The tranny and t-case should be a direct swap as long as you have the same engine. 2.9 right?
If the donor does not have the same wheelbase as you (if it is standard cab and you are extended cab) the driveshafts front and rear won't work. You need to find compatible ones. Or have them made.
I'm not sure if the 4x4 TTBs are a direct swap with the 4x2 TTBs. If they are it is going to be super easy. If not you will need to do some fabrication. I'm not familiar with TTB Rangers.
Good luck. You are in for a fun ride.
P.S. Don't forget that you front and rear diff gears have to match. If you have 3.55s out back and 3.73s up front you are going to have to rear gear to get them to match. Find out what each axle has.
If the donor does not have the same wheelbase as you (if it is standard cab and you are extended cab) the driveshafts front and rear won't work. You need to find compatible ones. Or have them made.
I'm not sure if the 4x4 TTBs are a direct swap with the 4x2 TTBs. If they are it is going to be super easy. If not you will need to do some fabrication. I'm not familiar with TTB Rangers.
Good luck. You are in for a fun ride.
P.S. Don't forget that you front and rear diff gears have to match. If you have 3.55s out back and 3.73s up front you are going to have to rear gear to get them to match. Find out what each axle has.
#5
#7
no. not really. the universal stuff will work and you can use the t-case if you don't mind rewiring for the electronic but the transmission is for a different engine so the bellhousing won't work. it might not even be the same transmission. i have no idea. check out the ranger station's tech library. looks some stuff up. get some knowledge and post what you know on there and someone will help you out. they have a lot more older trucks over there.
Thread
Thread Starter
Forum
Replies
Last Post
Dangerranger01
Engine & Drivetrain
177
03-26-2022 05:04 PM
Social Torture
General Ford Ranger Discussion
4
07-23-2013 10:30 PM
W1CKY
General Ford Ranger Discussion
10
11-24-2007 04:54 AM
Fx4wannabe01
Wheels & Tires Semi-Tech
15
09-12-2007 05:57 PM