Loose headlight assemblies on a 2001 ford ranger
#1
#3
Old Guy User…
iTrader: (12)
Chk that both mounting tabs are in place AND that the sliding bar that holds the hsg is slide all the way down.
You may need to remove the assemble before putting it back in correctly.
May need a little WD40.
added: when reinstalling the hsg, hold it in near the edges, then attempt to slide the bar to the locked position.
After that shake the unit a little to see if secured.
You may need to remove the assemble before putting it back in correctly.
May need a little WD40.
added: when reinstalling the hsg, hold it in near the edges, then attempt to slide the bar to the locked position.
After that shake the unit a little to see if secured.
Last edited by Scrambler82; 03-19-2012 at 10:31 AM. Reason: added: note / spl chk
#5
#7
In this picture, they move some at top right to bottom left. have tried messing with the adjusters some but cant change them enough to make headlites feel secure because the aim is effected to much.Why ford didnt put an ajuster shaft at all for corners is behond but I dont think I would have this problem if they did.
#10
You gave me an idea. I had a couple pieces of foam rubber and I bunched it up and put it behind the housings and now they dont move at all. Thanks alot... you the man.
Thread
Thread Starter
Forum
Replies
Last Post
For Sale: 04-05 fog light assemblies - PA
Clinton
OLD - Interior, Exterior, Electrical, & Misc.
10
04-09-2012 09:59 PM
HELMUT RONER
General Ford Ranger Discussion
12
04-21-2008 08:28 PM