i have a 2000 model ford ranger and im trying to put a 3 inch body lift on it!!!!how do i get the cab bolts out!!!me and my dad have tried everything and need help and cant get them to even move or make a noise or nothing!!!!please help we are in bad need of help!!!!!

PLEASE HELP!!!!!!!!!!!

 

Hold the bottom bushing with a large pipe wrench soak the top and bottom of the bolt with wd 40. If that dont work try heating it up.

 

hey man how did u get a pipe wrench to fit in the mount because my dad tryied and it wouldnt fit!!!!?thanks

 

there is thread lock in the blots heat the bottom of the large washer and the end of the bolt with a torch, when you start smelling burning rubber, stop put an impack on the top and hold the washer underneathe and it will come right out

 

thanks alot man u r a life SAVER!!!!!

 

One more question. My kit is a Summit and the directions SUCK!!!!!!!!.
It said to CAREFULLY BEND the fuel and brake lines by hand. That makes me a little squirrley. Would it be OK to start slowly raising the body and let the fuel and brake line take a natural bend or do I need to bend them by hand. And do I use a bottle jack or floor jack.

 

no dont do that and make sure there disconnected from the brake line holders on the frame...thats why you buy a PA lift not a summit brand lift

 

what is a pa lift?????

 

performance accessories.

 

o ok i see!!!!thanks

 

you better have before/after pics when you're done man. You're starting this project late haha.

aaron

 

i will do that ill show what it looks like when its done!!!!