2006 ranger lift?
#1
#5
its basically for looks. im still in high school getting ready to graduate so i want it it be as cheap as possible but good quality. I was thinking like the 3" spindle kit in the front and a block and U-bolt kit for the back but i dont really know. im new to the truck lifting world so i need some help.
#6
#8
#9
#16
#18
Originally Posted by quest51210
so why can my dads 199xl run 31's
#21
we used to have somebody on here who had 32's stock on his XLT, i think the thing is that you need to have the stock rims/backspacing to do that.
with the 3" spindles i would run 31's(what i have). FYI i have the fabtech spindles and you will love the wider stance and how much handeling it gives you.
and edge can go 32's and sometimes 33's stock(depending how much lift you can squeeze out of the torsion bars).
sorry but 35's on stock edge, i call BS. Greg has 35's on his edge and that is with a 3" spindle lift
with the 3" spindles i would run 31's(what i have). FYI i have the fabtech spindles and you will love the wider stance and how much handeling it gives you.
and edge can go 32's and sometimes 33's stock(depending how much lift you can squeeze out of the torsion bars).
sorry but 35's on stock edge, i call BS. Greg has 35's on his edge and that is with a 3" spindle lift
#22
Yea...I don't think you can turn worth a **** with 35s stock height. Hell....probably no suspension travel at all with that truck. Now I understand on the rear you could go huge, but on the front....it's just not practical and in my opinion.....just plain stupid having 35s on a stock edge. I have seen 32x1150s on a heavily cranked bar'd xlt 4x4 and 33s on a stock xlt 4x4. but never a ranger edge stock with 35s.
Post a pic of this truck with the 35s stock...i think we'd all like to see that.
Post a pic of this truck with the 35s stock...i think we'd all like to see that.
Thread
Thread Starter
Forum
Replies
Last Post