Need help driveshaft bolts!
Hey guys I am swapping my rear axle and I got one bolt off. The other 3 the socket keeps slipping. I am using a 12mm on a 12 point socket and it keeps slipping. I am using an impact gun and am scared I am going to strip it.
What else can I do to get them off?? Edit the socket it a 1/2 which I assume is the same. |
Have you tried adding some heat?
Head over to Canadian Tire and grab one of these: Mastercraft Maximum Impact Bolt Remover Set, 13-pc | Canadian Tire They've saved me many times! |
I'll try adding heat. It freaks my out with how near it is to the gas tank. How long you would you say I should keep the heat on for.
Damn Canadian tire is closed. |
Got them off.
A 1/2 inch won't cut it. I used a 12mm wrench and put it in the lever for my jack and used it like a breaker bar. Now just the hassle of getting the rear struts/shocks off. And figuring out how to disconnect all the Damn break lines and such. |
1/2" is closest to 13mm.
|
Wow damn yeah. I'm a little late here but you must use the 12pt 12mm (3/8 or 1/2 drive doesn't matter) to get those stubborn bolts off.
1/2 inch socket is near identical to 12mm. Too big. |
All times are GMT -6. The time now is 11:52 AM. |
© 2024 MH Sub I, LLC dba Internet Brands