Torsion Bar crank
#1
Torision-spindle install alignment ?'s
Alright, i had tires plus crank my torsion bars and do an alingment. It looks like the truck is a little lower on the passenger side. So i got under it and measured from the rubber stop to the a arm. and the left side is about an .5-1 inch lower. They also had to put on a new cambolt kit on the drivers side "which is higher"
I'm doing the spindle install next weekend. so if i just lower the torsion bar on the drivers side .5 an inch to make it level i for sure won't need the cam bolt kit on the drivers side right??? But what about the pass. side????
Or is it the opposite way around?
I'm doing the spindle install next weekend. so if i just lower the torsion bar on the drivers side .5 an inch to make it level i for sure won't need the cam bolt kit on the drivers side right??? But what about the pass. side????
Or is it the opposite way around?
#2
Thread
Thread Starter
Forum
Replies
Last Post
n3elz
Suspension Tech
46
10-30-2015 03:15 PM