Programing keys
 

I have a blank key for my 2001 ranger ....How to program it?

**You must have two original keys to perform this procedure. If you only have one key, you WILL have to take it to the dealer to get it programmed**


1. Insert and existing (working) key into the ignition cylinder.

2. Turn the ignition cylinder ON (RUN) and back to OFF. Ignition should stay on for at least ONE SECOND.

3. Remove the existing key and, within TEN seconds, insert a second working key and turn it to ON (RUN) and the back OFF. Ignition must be in ON for at least ONE second, but no more than TEN seconds. Remove the key.

4. Insert the new key before TWENTY seconds have elapsed and turn it to ON (RUN). Leave it the ON position for at least ONE second and turn back to OFF.

5. The security light will light up for THREE seconds to indicate that the new key has been successfully programmed.

6. To program additional keys, repeat steps 1 through 5


As a precautionary measure for all of the above procedures, you should wait at least one minute after you have performed this until you start your vehicle.

Locksmiths can also cut and program/add keys to Fords PATS(passive anti-theft system)
You don't need 2 working keys for this

And they are often faster and cost less than a Ford Dealer

If you don't have ANY working keys then a mobile locksmith can come to you, often costs less than towing truck to them or a dealer

Here is a fast way to get around the security chip in the key. Open back of key. Remove chip. Take apart steering colum till it looks like in the video. Tape chip to the place right above were the key goes. Test it with a normal Cheap copy key. If it works. Tape chip to that location. Close up colum. Here is a short video showing it work.

https://r16---sn-vgqsen7k.googlevide...28779043404003