This might be the dumbest question but i want to put my lift bloacks back in(Stock ones) i was curious if you lift the back does it bring the front up any?

 

Um...No. It will simply pivot the truck forward. Your fender height will be the same in the front.

Now block and a torsion bar crank and you'll be lifted and level.

 

I'd imagine that the front end would be tilted down because of the lift on the rear. It wouldn't lift or lower only tilt the appearance.

 

ohh ok i was curious because i remember when my torsion bar on the passenger side was cranked more than the drivers side it pushed the driverside rear down....

 

Also known as pivoting forward on the front axle.

If may have deceived you to think so, but it also just pivoted the front of the truck downward at the rear axle. If you measured at the highest point of the rear fender, it would also be the same.

 

Off-topic but the pm couldn't go through. Says you have me blocked or are not allowed to recieve pms???

I still have that tiny dash vent that goes beside the bezel. I was cleaning out my inbox and totally forgot about this. If you still want it let me know.

 

how much you lookin to raise?

 

i dont have anyone blocked from saending pms..hell i didnt know they had that feature...lol

 

steveo

ive got 1" block and new U-bolts ill sell you for cheap if your just wantin to lift an inch

 

well i got the factory 2 inchers thanks anyways man

 

How much you want for them?