Hey i am removing my rear seats anybody know what size torqs bit this is.

 

I'm pretty sure its T-45.. thats what I remember using to take mine out, but I could be wrong..

 

Bet it's a 45 or 47

 

I think it's a T-50, 99% sure. It was a year or so ago when I did mine, had to go get a Craftsman bit for like 8$. Gotta love craftsman though.

 

I'm 99% sure its a T-50.

 

Just removed mine yesterday. its a T45

EDIT: checked em out... it took a T47.

 

are you going to put yours back in when we are done ? I don't think i am they are never used.

 

I just checked my 2003 XLT S/C and they are T50. You might be able to get them out using a T45, but it is a very sloppy fit.

 

I'll most likely be keeping my jump seats in, I've used them a few times... they're good for that unexpected drunk friend at the bar who can't drive.

 

I always put the drunk friend in the front seat close to a window and door that they can get out of real quick.
Ben are you just removing them to get em outta the way. Or are you planning a sub woofer system or somethin like that.

 

Thats what the bed is for man, in case of any return flow, if you know what I mean.

I am 99% sure they are T50 at least mine were on my 02 XLT S/C

 

looks like the years varied...or people used wat kinda fit

 

I used a T45 and it seemed pretty snug to me.