Front end questions
#1
Front end questions
So, this weekend I am planning on going out to some junk yards and looking for some front end parts. I was wondering what years I need to keep my eyes out for. What I am looking for is: Front end springs, upper control arms and lower mainly. I have some camber problems and I think it is mainly from sagging springs. My front sits lower then it used to and it makes a ton of noise. Just trying little things here and there. I wanna look at read springs too and a hood.
#2
You shouldn't get used front end components like ties or ball joints. They could just as bad or worse than you're currents. Used springs are fine though.
Most here will recommend MOOG for ball joints and tie rods. They are lifetime warranty and you can get all 4 plus UCAs for $200. Not sure on tie rods. Probably another $20 each or so.
Most here will recommend MOOG for ball joints and tie rods. They are lifetime warranty and you can get all 4 plus UCAs for $200. Not sure on tie rods. Probably another $20 each or so.
#3
Thread
Thread Starter
Forum
Replies
Last Post
01_Camaro_SS
Exterior Semi-Tech
7
12-20-2016 05:00 PM
2003Ranger
Suspension Tech
19
12-24-2006 04:23 PM