General Ford Ranger Discussion General discussion of the Ford Ranger that does not fit in any other sub-forum.
Sponsored by:
Sponsored by: DashLynx

DLC doesn't meet minimum volt req 0n pin 16

Thread Tools
 
Search this Thread
 
  #1  
Old 09-15-2016
turnbuckle1's Avatar
Member
Thread Starter
Join Date: Jan 2013
Location: alliston ontario
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
DLC doesn't meet minimum volt req 0n pin 16

DLC doesn't meet minimum voltage required 0n pin 16 (failure for Emission test).
Is this related to a blown fuse on the left power outlet on dash? Had a problem 2 yrs ago getting a new key made , computer said It could not match the code ... long and short (and an hour electrical labor , was the fuse to the same left power outlet. replaced , all was well.... didn't realize this outlet/fuse was such an issue, and do u think this is why i have computer problems now....will get my tester in the morning.

turnbuckle
 
  #2  
Old 09-15-2016
Join Date: Nov 2015
Location: Evansville, Indiana
Posts: 1,635
Likes: 0
Received 3 Likes on 3 Posts
check every single fuse you can find.

Are you plugging anything into this power port?
 
  #3  
Old 09-16-2016
turnbuckle1's Avatar
Member
Thread Starter
Join Date: Jan 2013
Location: alliston ontario
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
found a 20 amp fuse , replaced it , checked the left power outlet and had power there. went to the emission test and PASSED!!. I run the right outlet with a power splitter , 2 usb , & a 12volt , to a power eliminator , never had any probs with it,....right side has blown b4 , so I don't use it. The surprise was 2 yrs ago , when I had to replace a key and the computer would not recognize key reset. same problem was the left power fuse.
Sooooooo the moral to this story is check that fuse/outlet , it can cause grief u never tho't of !! (damn computer....lol)


TURNBUCKLE
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
racoonfrenzy
General Technical & Electrical
0
05-03-2013 08:39 PM
Fx4wannabe01
Snapshots
32
10-02-2009 04:08 PM
Fx4wannabe01
Snapshots
34
02-20-2009 12:07 AM
Grains
Exterior Semi-Tech
11
04-14-2008 09:10 PM



Quick Reply: DLC doesn't meet minimum volt req 0n pin 16



All times are GMT -6. The time now is 09:58 PM.