anyway to push quarter panels out? pic
#1
anyway to push quarter panels out? pic
ok its a 96 ranger I saw built on speed. Thing is awesome. But look at the quarter panels, they look stock (correct me if im wrong). I want to push them out a bit. How do you do this? heat and a scissor jack and a good rectangular piece of wood? any info or a link here?
#5
theres that word buy haha im kidding. I would be into this if I was going the fiberglass/prerunner/long travel direction. But Im just looking for the width of fender flares without fender flares. stretching my panels seemed like the way to go. Im only going for an inch max
Thread
Thread Starter
Forum
Replies
Last Post
NewShockerGuy
General Ford Ranger Discussion
0
09-02-2014 09:13 AM
Otis_Ranger
OLD - Interior, Exterior, Electrical, & Misc.
1
08-09-2010 09:45 AM