Question about taking off front bumper
#1
Question about taking off front bumper
Hey guys. I picked up a new winch and now need to get a receiver fabbed up for the front. I was wondering if there are any air bag sensors or anything on the bumper itself that I need to be aware of when taking it off. Do I need to pull the fuse?
Also, I am going to weld it to the front frame so do I need to take off the entire bumper or just the valance?
I need to figure out which vehicle to get the receiver off of at the junkyard or which will work best. I have a 2002 Edge 4x4 with a 3" BL and not looking to lose the valance for good.
Also, I am going to weld it to the front frame so do I need to take off the entire bumper or just the valance?
I need to figure out which vehicle to get the receiver off of at the junkyard or which will work best. I have a 2002 Edge 4x4 with a 3" BL and not looking to lose the valance for good.
#3
#6
Thread
Thread Starter
Forum
Replies
Last Post
Sonic04Edge
General Ford Ranger Discussion
11
06-04-2005 08:06 PM