Need some help is this gonna work for me??
#1
Need some help is this gonna work for me??
Hey guys I have a stock 05 lvl2 and I'm going to be adding some new parts to it, I have read alot of posts here so I think I know what I want to do. I just want to make sure that this combo will work well and also look good.
3in bl
5in rcd lift
15x10 mt classic locks
35x12.5x15 mt baja claws
possible new from drive shaft
regear to 4.56
3in bl
5in rcd lift
15x10 mt classic locks
35x12.5x15 mt baja claws
possible new from drive shaft
regear to 4.56
#4
#7
#9
Member
iTrader: (10)
Join Date: May 2006
Location: Boerne, TX
Posts: 1,997
Likes: 0
Received 0 Likes
on
0 Posts
those you would want a 10" wide rim for...i wouldnt put those on a 8" wheel...
you should be ok with everything. although I have to ask why everyone thinks you must double lift to run 35s....hell if i had a body lift i would be runnin 37s! i have just the 4" superlift and im runnin 35s NO problem at all...other than those damn cv axles.
IMO....dont spend a dime on any of those lifts....take half that money and do a solid axle swap and run 35s with tons of room to flex. a shop could do it for about the same price as that RCD lift...
just my .02
you should be ok with everything. although I have to ask why everyone thinks you must double lift to run 35s....hell if i had a body lift i would be runnin 37s! i have just the 4" superlift and im runnin 35s NO problem at all...other than those damn cv axles.
IMO....dont spend a dime on any of those lifts....take half that money and do a solid axle swap and run 35s with tons of room to flex. a shop could do it for about the same price as that RCD lift...
just my .02
#13
A 10" wheel will make it look wider, but it makes the tire shorter. My Xterrains were shorter cause of my 15x10 rims.
Thread
Thread Starter
Forum
Replies
Last Post
Jleng357
General Ford Ranger Discussion
2
12-23-2012 10:58 AM
Tys 4x4 FTW
General Ford Ranger Discussion
17
01-17-2011 06:29 PM