how to take off stock step bars
#1
how to take off stock step bars
just as the title says, i decided i'd take off the stock step bars that came on my 07, and sell em to a buddy that also has a ranger.
how would i go about getting them off?
i briefly took a look at em, and didn't see bolts that looked like they were for the bars. but it was dark out, with cell phone light.
thanks.
how would i go about getting them off?
i briefly took a look at em, and didn't see bolts that looked like they were for the bars. but it was dark out, with cell phone light.
thanks.
#9
#10
yeah i took em off yesterday,
and damn, it was freezing cold outside, it had just snowed the day before, and i found some mud to go have fun in. me and my buddy had a lot of fun pulling them off lol
can't go wrong with mud constantly falling on your face as you undo the bolts.
but yeah, they were a little tight, but not too bad, and it makes a huge difference.
i think once i get a lift i might get some aftermarket step bars, that are pulled up a bit closer to the truck, but these ones just made it look like a grampa truck at stock height.
and damn, it was freezing cold outside, it had just snowed the day before, and i found some mud to go have fun in. me and my buddy had a lot of fun pulling them off lol
can't go wrong with mud constantly falling on your face as you undo the bolts.
but yeah, they were a little tight, but not too bad, and it makes a huge difference.
i think once i get a lift i might get some aftermarket step bars, that are pulled up a bit closer to the truck, but these ones just made it look like a grampa truck at stock height.
Thread
Thread Starter
Forum
Replies
Last Post
Jay524
OLD - Interior, Exterior, Electrical, & Misc.
15
06-09-2014 08:17 PM
morsetaper2
OLD - Interior, Exterior, Electrical, & Misc.
4
08-29-2013 05:51 PM
BILTRITE BULLIES
OLD - Suspension, Tires, & Wheels
31
07-03-2010 08:50 PM
red_fx2
General Technical & Electrical
0
12-04-2006 02:54 PM