Could bad hubs be causing a horrible catching/grinding on 99 4x4
#1
Could bad hubs be causing a horrible catching/grinding on 99 4x4
Hey, I'm new to the site so please forgive me if I've posted this in the wrong place. I recently acquired a 99 ext cab ranger 4x4. I've been replacing odd and end parts getting it where I want it but I'm going at it slow be causing I am not much of a mechanic. Recently I found that the hubs were bad/not working properly on the front end. I've ordered manual locking hubs but driving it this evening with old hubs I started getting a bad banging or catching with a serious grinding to follow. This would occur and last only a short time only to happen again about 100 yards down the interstate. At a slower speed it was happening randomly and coming to a complete stop seemed to rest things. I could get a smooth ride for about 200 yards then catch, shake and start all over. I was told the bearing were recently replaced by the previous owner. Could the bad hub be causing this issue? Any info would be helpful.
Thread
Thread Starter
Forum
Replies
Last Post
pro93
General Ford Ranger Discussion
5
02-02-2013 09:33 AM
m00m0bile
Drivetrain Tech
1
08-31-2009 10:23 AM
rngprerunner
General Technical & Electrical
4
06-07-2006 04:06 PM