Paid $50 and got my tires balanced. No more shaking steering wheel for me.

 

Wow!

 

got rear ended by an idiot lol

 

Nice!

I scanned my truck tonight with my new scan tool.



Got two misfire codes. Got a new set of wires ordered up for it that will be in tomorrow.

 

Oil & Filter change!!!!!

 

took a load of stuff from my shed & delivered it out to my box trailer at my parents, had some fun in the drifted snow.

 

Did the wheel cylinders, shoes and hardware on kyles truck.

 

Installed new plug wires... reset check engine light.

 

Washed it for the first time in like 3 months!

 

I got the truck stuck yesterday, and someone backed into it today when my mom was driving it. Blue's not having a good weekend...

 

Santa delivered this:





Gonna be awhile before we get a melt so I'll have the pleasure of installing it in this:

 

my names steve , im new here ,,, whats goin on fellas...gotta question for anyone whos willing to help...
i just took the heads off of my 90 ford ranger 4x4 with a 2.9l ...not sure if i HAVE to have the heads shaved or not or whether its a bad idea to not have it done and just replace the gaskets and torque them back to spec...i also had alot of water in them...id like to have them ported and polished but because of raised compression im afraid of ruining the lower half (without replacing pistons crank ..etc)
any help highly appreciated

 

Welcome to the forum, You may get better response by posting this in the correct section as a new thread. FYI.

 

Replaced the battery for free

 

replaced the power steering pump and replaced the trans filter. Both were successful, the pump doesn't leak and the tranny whine is gone!

 

I wanna start on my lift but its too damn cold out

 

Getting the new Thrush muffler and tail pipe installed today on my Ranger.

 

Had to put a new Tie Rod end on her after the driver's side came off while my dad was driving it. Bout near yanked the truck into the other lane (4 lane road) and he had to limp it to a parking lot.

 

Well, I splurged again and purchased a 'little bit' of sound deadening for the truck....

 

Dude you must be loaded or something.

 

X2! Dude, wanna share some???

haha, just messing with ya. I'll be looking for your install, thinking about doing that later down the road.

 

Ordered new ply tie rod dust boot passanger one went to crap

 

LOL - Yeah, I'm a firm believer of the 'Go Big or Go Home' saying!

I've been accused of going slightly overboard when I put my mind to doing something.

 

Lol in that case upgrade those mirrors already!

 

Yeah I know.....

Purchased them like months ago - haven't even put them on yet!