A little help please !
#1
A little help please !
I am looking for someone in the Oklahoma City, OK area, who owns a Stepside Ranger to assist me in getting a rear bumper made.
Custom 4x4 Fabrication, 11825 S.E. 109th, Oklahoma City, OK 73165, phone: 1-405-799-7599, has stated they will make a rear bumper for a steppie but they do not have Truck to go by.
If someone had the time and wanted to be the pilot truck for this project and go by their shop so they can first get some measurements and second be available for fitment checks, it would help out not only me but other Steppie Owners.
I will contact them again to make sure they are willing to do this.
So, anyone in the OK City Area want to help out ?
thanks
Custom 4x4 Fabrication, 11825 S.E. 109th, Oklahoma City, OK 73165, phone: 1-405-799-7599, has stated they will make a rear bumper for a steppie but they do not have Truck to go by.
If someone had the time and wanted to be the pilot truck for this project and go by their shop so they can first get some measurements and second be available for fitment checks, it would help out not only me but other Steppie Owners.
I will contact them again to make sure they are willing to do this.
So, anyone in the OK City Area want to help out ?
thanks
#4
Looks like he will have a steppie bumper soon for a pattern, just the bumper.
Now for a truck for fitment.
I can’t say but I would think, if you get on this guys good side, he might give you a discount on a new HD Rear Bumper for a steppie, maybe the fist one out there.
For anyone - info, this guy does a great job, his welding is above average and the plating used is 3/16” steel (usually) so if you liked what he is building and wanted to buy one you would get a great bumper.
Thanks Taylor for the push.
Now for a truck for fitment.
I can’t say but I would think, if you get on this guys good side, he might give you a discount on a new HD Rear Bumper for a steppie, maybe the fist one out there.
For anyone - info, this guy does a great job, his welding is above average and the plating used is 3/16” steel (usually) so if you liked what he is building and wanted to buy one you would get a great bumper.
Thanks Taylor for the push.
Last edited by Scrambler82; 07-19-2012 at 04:17 AM.
Thread
Thread Starter
Forum
Replies
Last Post
pushdeck
General Technical & Electrical
10
03-18-2007 09:52 AM