1989 2.3L Motor Swap - Bare minimum wiring?
#1
1989 2.3L Motor Swap - Bare minimum wiring?
I am swapping a 2.3L EFI into a sand rail and I was not provided a harness with the engine :/
I have the ECU, and basically a pile of connectors snipped from the wiring harness...
What is the bare minimum needed to make the motor run electronic wise?
Does anything need to be bypassed? Clutch switch? Neutral switch?
I have the ECU, and basically a pile of connectors snipped from the wiring harness...
What is the bare minimum needed to make the motor run electronic wise?
Does anything need to be bypassed? Clutch switch? Neutral switch?
Thread
Thread Starter
Forum
Replies
Last Post
mp5raycer
General Technical & Electrical
1
09-20-2014 11:09 PM
mcramer15
Project Logs
183
10-16-2011 05:39 PM
Tys 4x4 FTW
General Ford Ranger Discussion
14
04-12-2009 07:22 PM