HELP!! How long before 2003 supercab Computer gets reading again!!!
#1
HELP!! How long before 2003 supercab Computer gets reading again!!!
I went to get my emissions done today to find out that it couldn't be tested due to the fact that there were 2 blown fuses so the computer wasn't getting all of the necessary readings. I replaced the fuses and the guys at the emissions station said that I could take up to 50 miles before the trucks computer starts reading everything again. Another guy there said to look it up on to see if there was a easier and quicker way, like driving the truck for 65 mph for ten minutes straight to get all the readings quicker. Anybody know anything about this?? I would like to get the emissions done today so I can go to the DMV tomorrow and get the permanent registration and plates
#3
Assuming the computer will read the data when you go into open loop this might be the best course of action...
1. Disconnect battery
2. Tap your brakes while battery is disconnected to get all the power out of the computer
3. Reconnect battery.
4. Take truck onto highway for a 10-15 minute 65 mph drive(assuming thats legal).
That should take the computer from closed loop to open loop where it would have to get all the senser data readings.
1. Disconnect battery
2. Tap your brakes while battery is disconnected to get all the power out of the computer
3. Reconnect battery.
4. Take truck onto highway for a 10-15 minute 65 mph drive(assuming thats legal).
That should take the computer from closed loop to open loop where it would have to get all the senser data readings.
#4
Thread
Thread Starter
Forum
Replies
Last Post
07silver4.0Lsport
General Ford Ranger Discussion
1
11-16-2010 11:51 AM
lemmy
General Ford Ranger Discussion
3
07-08-2008 08:26 PM