DDM Hid's mounting spots Help
#1
DDM Hid's mounting spots Help
Hi guys I have always ordered ddm hid for years, this is the first with the ranger, they are already on, just need to mount/tie them off and just basically clean them up a bit so that they are neat, any tips, anyone have pics or would like to take pics and show off their skills, thanks so much .
#2
#4
^^^same way i did mine when i had hi/lo
I have since switched to 55 watt heads with no hi/lo I was lazy and didnt want to take the intake and battery out so i did this
works just fine clears the hood with no issues
if you ordered the fogs too I believe i just cleaned the frame real well and used the 3m tape and then zip tied around them. no issues there either!
I have since switched to 55 watt heads with no hi/lo I was lazy and didnt want to take the intake and battery out so i did this
works just fine clears the hood with no issues
if you ordered the fogs too I believe i just cleaned the frame real well and used the 3m tape and then zip tied around them. no issues there either!
#5
I appreciate the response, I a looking for a cleaner look in a more protected area, I may even buy some large heat stink and wrap them so that they are protected from water, too much debris and water can get under their where the fogs hid are, i love the battery and intake area, I will figure it out and get the results i'm looking for. Thanks a bunch men.
Thread
Thread Starter
Forum
Replies
Last Post
annguyen1981
General Ford Ranger Discussion
31
08-17-2010 11:33 PM
jaycheetwood
Ranger Products, Company, & Member Reviews
110
04-07-2009 01:15 PM