Help wiring OHC - GEM module question
#1
Join Date: Mar 2009
Location: 559, CA
Posts: 1,174
Likes: 0
Received 0 Likes
on
0 Posts
Help wiring OHC - GEM module question
My GEM module seems to look different than on the 2 guides I've read. (Mossyoak's guide and the CarDomain guide).
First, the bottom of my GEM module is not divided into 2 harnesses like on the pics I've seen, and I don't have a red/blue wire coming out of the bottom of my module at all. I only have red/black and red/pink.
I do see a red/blue wire on the other harness at the top left of this picture. What should i do? Use the red/black? Or use the red/blue on the top left harness?
Also, my "yellow/black" coming out of my module is actually yellow/gray. Just verifying that this is the wire I need to tap for the yellow/gray coming from the OHC.
I have a 98 by the way.
First, the bottom of my GEM module is not divided into 2 harnesses like on the pics I've seen, and I don't have a red/blue wire coming out of the bottom of my module at all. I only have red/black and red/pink.
I do see a red/blue wire on the other harness at the top left of this picture. What should i do? Use the red/black? Or use the red/blue on the top left harness?
Also, my "yellow/black" coming out of my module is actually yellow/gray. Just verifying that this is the wire I need to tap for the yellow/gray coming from the OHC.
I have a 98 by the way.
Last edited by gts007; 06-09-2009 at 04:34 PM.
#3
#5
ya mine was yellow black also now that i remember haha i just don't want to go out and rip it apart. plus its dark already or i would of done it
#6
Join Date: Mar 2009
Location: 559, CA
Posts: 1,174
Likes: 0
Received 0 Likes
on
0 Posts
#7
Member
iTrader: (2)
Join Date: Feb 2009
Location: La Grande, OR
Posts: 320
Likes: 0
Received 0 Likes
on
0 Posts
blue/red and yellow/black from the radio harness
this is from mossy oaks how-to
https://www.ranger-forums.com/forum2...c-install.html
Black (BK) - ground (mounted to the mounting bracket)
Yellow/Gray (YE/GY) - console electronics power (goes behind the radio)
Blue/Red (BL/RD) - console display dimmer input (goes behind the radio)
Green/Orange(GN/OR) - Map light power (goes to the dome light)
Black/Blue(BK/BL) - Dome light power (goes to the dome light)
Lt. Blue/White (BL/WH) - Temp sensor (front of the truck)
Lt. Blue/Yellow (BL/YE) - Temp sensor (front of the truck)
Gray/Black (GY/BK) - speed sensor (not used by some, but necessary) (goes behind the radio.
then i ran the yellow/gray, blue/red, and gray/black wires through the headliner.
Thread
Thread Starter
Forum
Replies
Last Post