Wiring aftermarket power doors to stock door switches
#1
Wiring aftermarket power doors to stock door switches
Ok this is like the 4th thread i've started about these power door locks so bear with me lol. I have aquired a set of stock power door bezels and am going to wire up the switches to activate the acutators. I have this diagram but don't really understand the top part. I think the (LCK) and (ULK) boxes are relays but which wires go to which parts of the relays? Also when it says that the NO goes to the PS2, what the heck does that mean? My actuators only have 2 wires, the Blue and Green that already have wires running to them. The only thing I really need to know is which wires go to which ports on the relay and what the NO going to the PS2 means. Thanks for all your help guys. I'm going to do a thorough walk thru of installing aftermarket power door locks with keyless entry once I'm done.
Last edited by 04blackedge; 08-26-2008 at 12:49 PM.
#2
This diagram was designed for dual pulse system (unlocking passengers door separately from drivers) but should help. Just delete the bottom relay and reroute the blue wire coming off the passengers actuator and splice it into the blue wire connected to the drivers actuator for your setup.
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
TommyC
General Ford Ranger Discussion
7
09-09-2015 12:34 AM
For Sale: Power door handle bezels & switches - PA
Clinton
OLD - Interior, Exterior, Electrical, & Misc.
23
09-15-2012 11:28 PM
03DualSport
General Ford Ranger Discussion
1
12-11-2006 04:36 PM