blinker mod
 

I attempted to hook up the blinker mod
I wired everything up like the picture shows but when I hook back up the battery and turn on the hazards the fuse pops.

Now when I did this I only had the driver side hooked up I hadnt touched the passenger side

You did the same thing i did here my help thread....
https://www.ranger-forums.com/forum2...ad.php?t=49681

Okay so I take wire cutters and just cut the balck wire in half and only use the part that is going into the light socket? and just tape off the one end going into the wire harness and discard it

yep

LOL that was to easy....


I did screw up I forgot to cut the passenger side wire and used the wire clip. I then turned my blinker on and my dome light was flashing and my gauge tuen signal was very faint. I fixed that in 3 min I have it down now

I did it too, but I think I get it now, I will try it tomorrow some time...

Now how could that have happened? Your dome light was flashing after the blinker light mod?? Dude, you must have really, really done something retarded?

The blinker light mod consists of splicing wires in the headlight area......WTF did YOU do?

I did it yesterday afternoon, it took like 15 mins. It wasn't that complicated at all, I guess I read the other set of directions wrong or somethin.

It was over a year ago so I don't know. :shrug:

The dome light wasn't flashing like it was a turn signal. It was barely on and just like a flicker. I do remember that much