I have a 06 ford ranger sport with out cruise. I changed column for tilt column now I have a new wheel with buttons will a clock spring from explorer sport 2000-2003 or 2000-2005 explorer sport track interchange so I can install factory cruise that wires will fit to factory dash wire loom ? I have been told that but before I buy would like to know. Part #5L5T-14A664-AA does any one know

 

You can cross-reference part numbers with Rockauto.

If the part numbers between the same manufacturer line up, then the answer is Yes..... Usually.

Do know that the Explorer began changing a lot in 2002. 95-01 is the most compatible, wiring wise, with the Rangers from 98-03. In 04 the Ranger's wiring began changing quite a bit, including the removal of the GEM and went to a SJB. Although that being said, just about anything that can be done from 98-03 can usually be done to an 04-11, albiet just a bit more complicated in some cases.

 

thank you I think ill give it a try the clock spring is low cost and a lot cheaper than pulling dash. Thank you

 

If you replaced your column with a tilt unit that had the cruise pods on the steering wheel, you should already have the correct clock spring in it. Look under the dash and you should see a tan connector that would coincide with the pigtail from the clock spring harness.

 

No bottom connector different tilt exchanges all they to 2011 but clock springs changed in 2007, 06 bottom connector and air bag connector different found clock spring with speed in Canada 80.00 it will work. Thanks

 

I didn't think that part changed, but I stand corrected!