ok, i recently got a set of four 48in LED tubes and three 36in tubes. i mounted two 48's right to the frame under the doors, but i cant figure out where to put wires through the firewall into the cab. i really really dont want to drill at this point and i'd like to stick the switch for power and patterns in my glove compartment. I have a 2000 Ford Ranger Supercab with the 4.0 V6. if anyone has any tips or tricks they can offer please post them. thanks

Steve

 

under the brake booster there is a rubber gromit its empty you can run wires through there. or if you look at it from the inside its like above adn to the left of the brake petal

 

Send a PM to Vin Diesel, him and Paul walker could help ya out.

 

lmao ^^^

 

lol^^how do you mount them to the frame, just with clips or sumthing?

 

get some pics when you are done.

 

They come with self-tapping screws and clamps. Or the ones i've seen did.

 

^^^Yep same for the ones i installed

 

ok, i looked all over for the rubber grommet up and to teh left of the brake pedal but i dont see one that is un-used. im gonna post some pics just in case im missing something. these are pics taken of the left side of the brake pedal.

 

go under your dash, and fallow the cable to pop your hood. it should be right above the stering link to the right a little. thats where i went in. your going to have to pop the rubber piece out, run the wire and pop the rubber piece back in. I would get a pic for you but my parents have the camera in vegas with them.

 

ok, i am completely done except for one thing.now this is probably a stupid question but how do i run something to the fuse box? actually i probably didnt word that right so let me try to explain. ive got my (+) wire right at the fuse box. fuse 20 is "not used" how do i get power to that socket and how to i connect the (+) wire to that fuse terminal?

 

power it to the accessory wire it should be a gray with yellow stripe

 

Look for a fuse that already has power.
i think 21 has power to it, but im not sure, im not by my truck right now.
Make sure if you want power going to it even with the key off, that you connect it to a fuse with power when the key is off.