General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Mass air flow sensor?????

Thread Tools
 
Search this Thread
 
  #1  
Old 06-29-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
Mass air flow sensor?????

hey guys im new trying to get some help first...

ok i have a 95 Ranger with a 4.0 in it ok when i drive it for about 30-45 minutes it will make a loud HUMMMING sound sounds like its coming from the MAFS but im not sure i know its not the air filter or anything so think its the MAFS? i also get bad gas mileage and it kinda "studders" when im driving sometimes

thanks

also it doesnt do it when its cold outside? and if i do have to replace it the cheapest i can get it is 230$ =/
 

Last edited by simmons; 06-29-2007 at 07:38 PM.
  #2  
Old 06-29-2007
nbro3232's Avatar
Member
iTrader: (1)
Join Date: Jul 2006
Location: Nokomis, FL / Tallahassee
Posts: 784
Likes: 0
Received 0 Likes on 0 Posts
I got a refurbished one at autozone for half that for my 3.0L. If the maf was bad it would most likely throw a code.

I'm not really sure where the humming sound would be comming from, maybe someone else will chime in.
 
  #3  
Old 06-29-2007
Mike9825's Avatar
Member
Join Date: Jun 2006
Location: Willard OH
Posts: 489
Likes: 0
Received 1 Like on 1 Post
Welcome to R-F!

Do you have a check engine light on? If so, take it to your local Autozone or Advance Auto Parts, they'll scan for free and tell you what's wrong.

Also, is it possible to record this humming sound and upload it on here? when a vehicle makes a humming sound, that's a broad statement but you've already narrowed it down to the engine so that's a start.

I'm with nbro, if the MAF was bad it would throw a code triggering the check engine light. -Mike-
 
  #4  
Old 06-30-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
ill try to take a video when i get off work today and post it

nope the check engine light is off

BTW im almost poistive its coming from the MAFS because i can disconect the pipe from it while its running and it stops
 
  #5  
Old 06-30-2007
Takeda's Avatar
Level I Supporter
Join Date: Aug 2006
Location: Durham, NC
Posts: 3,657
Likes: 0
Received 7 Likes on 3 Posts
The IAC valve is what normally causes a humming noise, not the MAF sensor.
You can try cleaning it, but normally they have to be replaced.
 
  #6  
Old 06-30-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
whats a IAC valve? and wheres it located? sorry ima noob
 
  #7  
Old 06-30-2007
drummerjamesh's Avatar
Member
Join Date: Mar 2007
Location: Huntsville, AL
Posts: 62
Likes: 0
Received 0 Likes on 0 Posts
take off the top cover on the engine, the big silver circle is the IAC
I think its the same on OHV as SOHC?
 
  #8  
Old 07-01-2007
Takeda's Avatar
Level I Supporter
Join Date: Aug 2006
Location: Durham, NC
Posts: 3,657
Likes: 0
Received 7 Likes on 3 Posts
Here is a picture of the IAC. It's on my 3.0L, but the one on the 4.0L should look similar. It's located on the upper intake next to the throttle body:

 
  #9  
Old 07-01-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
ill put one of those on and see if thats it if not im going to buy a new MAFS
 
  #10  
Old 07-01-2007
MonsterGuy's Avatar
Member
Join Date: Aug 2005
Location: Haverhill, MA
Posts: 1,907
Likes: 0
Received 0 Likes on 0 Posts
i g2 replace mine. i cleaned mine and it started to hum and now after about 2 weeks of driving like that it just threw a code today lol.

ya if its humming its the IAC not the MAF
 
  #11  
Old 07-01-2007
DangaRanger99's Avatar
Member
Join Date: Mar 2006
Location: Farmington, NH
Posts: 1,209
Likes: 0
Received 0 Likes on 0 Posts
Been there done that!! Mine used to do it bad, but thanks for R-F i figured out the problem!
 
  #12  
Old 07-03-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
ok i was wondering something if it is the IAC valve would it echo down through the intake pipe and sound like its coming out of the end? around the MAF? i mean it gets LOUD at the end by the MAF and filter



well pulled the IAC off the stuck my finger in one of the holes and i got a black gummy oil on my fingers? is that normal? i dont think it is how do i go about cleaning that? also the IAC valve is ony 60$
 

Last edited by simmons; 07-03-2007 at 10:22 AM.
  #13  
Old 07-04-2007
97ranger xlt's Avatar
Member
Join Date: Feb 2007
Location: PSL, FL
Posts: 515
Received 9 Likes on 7 Posts
blast out the the iac with carb cleaner, dry it well, then re-install and see what happens...
 
  #14  
Old 07-05-2007
simmons's Avatar
Member
Thread Starter
Join Date: Jun 2007
Location: Dunbar West Virginia
Posts: 8
Likes: 0
Received 0 Likes on 0 Posts
i did that .... still does it but i went to parts america and they have two for my model ? does it matter what one i put on it?
 

Last edited by simmons; 07-05-2007 at 07:29 PM.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
pelab
2.9L & 3.0L V6 Tech
8
04-14-2013 01:13 AM
markw_06
2.9L & 3.0L V6 Tech
17
04-14-2013 12:59 AM
06fx4jb83
4.0L OHV & SOHC V6 Tech
2
10-22-2008 02:12 PM
RangerRunner96
2.9L & 3.0L V6 Tech
5
08-29-2008 01:01 PM
Redbeard90
SOHC - 2.3L & 2.5L Lima Engines
10
08-21-2007 09:28 PM



Quick Reply: Mass air flow sensor?????



All times are GMT -6. The time now is 10:12 PM.