General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Air Idle Speed Controller WANTED: 4C 2.0 Carbed

Thread Tools
 
Search this Thread
 
  #1  
Old 05-24-2011
TheRangerAntique's Avatar
Member
Thread Starter
Join Date: Feb 2011
Location: South Jersey
Posts: 32
Likes: 0
Received 0 Likes on 0 Posts
Air Idle Speed Controller WANTED: 4C 2.0 Carbed

Looking for Idle speed controller. This is a module found on the passinger side, mounted on the wheel plastic insert covers, under the hood. It is a electronic module about 8 inches square, three bolts holding it with a large connector in the middle.

These were on 1985 and 1986. Others I don't know. The number on the lable of the module is: E5TF-9L513-AA. The Ford part number is: E5TZ-9L513-A. If you have one of these I can use it.

I diden't see a wanted section, for parts and such. So I figured this is the right heading for this thread. The vehicle this comes from should NOT have the black tarish area disturbed. Or the tar starting to run out of the square holder.

If you have one, from a old ranger, or a parts truck, or just sitting on the shelf. Please let me know. I think my engine will run better with this module replaced.

Thanks.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Cody_288
Forced Induction & N20 Tech
24
12-26-2010 01:57 AM
bmxrider11225
8-Cylinder Tech
10
02-15-2009 06:46 PM
SHORANGERBIRD
Forced Induction & N20 Tech
0
04-25-2008 08:46 AM



Quick Reply: Air Idle Speed Controller WANTED: 4C 2.0 Carbed



All times are GMT -6. The time now is 01:33 AM.