AC Clutch
#1
AC Clutch
2004 XLT, 4.0L, Noise coming from AC clutch best described as 2 pieces of metal sliding against each other. Now the clutch will not engage. I can rotate the clutch easily by hand. I am assuming the clutch needs replacing.
Could this be electrical ? I tried to test for current but I was unable to disconnect the two wires going to bottom of the clutch.
Suggestions ?
Could this be electrical ? I tried to test for current but I was unable to disconnect the two wires going to bottom of the clutch.
Suggestions ?
#2
RF Veteran
iTrader: (1)
Check fuse 25 in engine bay fuse box, 10amp, thats the AC clutch fuse, if its blown then clutch is most likely shorted, and connector may have gotten hot so hard to remove
You can just replace the clutch part, Google: 2004 ford ranger AC clutch replacement
Pretty much all years and all Fords used the same replacement methods, but different parts of course
You can just replace the clutch part, Google: 2004 ford ranger AC clutch replacement
Pretty much all years and all Fords used the same replacement methods, but different parts of course
Thread
Thread Starter
Forum
Replies
Last Post
lemmy
DOHC - 2.3L Duratec / Mazda L Engines
0
12-31-2020 09:28 PM