Mustang Dome Install help
#1
Mustang Dome Install help
Ok I've followed everything within this thread:
https://www.ranger-forums.com/forum2...ead.php?t=8212
I'm installing a 90-93 mustang black dome with map lights. It looks just like the explorer dome lights available in the classifieds. My problem is that I have no map lights. The center light works, but no maps. There seems to be a loose connection too as the center light wasn't coming on until I went to remove the cover to triple check everything a billionth time. I'm wondering if this is because the screw that's connected to the wire I ran doesn't line up to any pre-existing holes. The hole layout is exactly the same as the type of dome light used within the how-to though?
Any help/ideas?
https://www.ranger-forums.com/forum2...ead.php?t=8212
I'm installing a 90-93 mustang black dome with map lights. It looks just like the explorer dome lights available in the classifieds. My problem is that I have no map lights. The center light works, but no maps. There seems to be a loose connection too as the center light wasn't coming on until I went to remove the cover to triple check everything a billionth time. I'm wondering if this is because the screw that's connected to the wire I ran doesn't line up to any pre-existing holes. The hole layout is exactly the same as the type of dome light used within the how-to though?
Any help/ideas?
Last edited by Lefty04LevelII; 09-15-2006 at 08:40 PM.
#2
Well, I blew fuse #13....off to get fuses and bulbs (can't tell if one of the bulbs in burnt out).
Another question, I have 18 gauge wire that I used as my power wire. Should I maybe have used 16?
Screw it, I'm picking up 16 and 14 gauge while I'm at the Anti-Christ getting fuses and bulbs.
Another question, I have 18 gauge wire that I used as my power wire. Should I maybe have used 16?
Screw it, I'm picking up 16 and 14 gauge while I'm at the Anti-Christ getting fuses and bulbs.
#3
#4
I'm a dork....
I thought my map bulbs were good (there was no blown filament floating about in the bulb). Everything was wired up correctly. I ran up to wal-mart (anti-christ from ealier) to grab fuses since I blew #13 (15a). I figured I'd take the map light bulbs with. They were toast compared to new. Got home, hooked everything back up like I had it first time and viola, it works!
1 mod down, one OHC to go.
Anyone have a spare 97 or compatible OHC harness lying around?
I thought my map bulbs were good (there was no blown filament floating about in the bulb). Everything was wired up correctly. I ran up to wal-mart (anti-christ from ealier) to grab fuses since I blew #13 (15a). I figured I'd take the map light bulbs with. They were toast compared to new. Got home, hooked everything back up like I had it first time and viola, it works!
1 mod down, one OHC to go.
Anyone have a spare 97 or compatible OHC harness lying around?
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
Interior, Exterior, & Electrical
41
07-03-2019 09:02 PM
Yukon Ranger
General Technical & Electrical
10
08-22-2009 11:49 AM