Ranger-Forums - The Ultimate Ford Ranger Resource

Ranger-Forums - The Ultimate Ford Ranger Resource (https://www.ranger-forums.com/)

- General Technical & Electrical (https://www.ranger-forums.com/general-technical-electrical-18/)

- - No Hubs? (https://www.ranger-forums.com/general-technical-electrical-18/no-hubs-57452/)

wvcat

01-23-2008 08:40 AM

No Hubs?

I bought a axle for my edge 4x4 conversion and the spindles have no hubs. Did for actually make a full time setup(what were they thinking) anyway what are my choices to add manual or vacumn hubs. Do the bearings have to be changed? Any advice?
John

zabeard

01-23-2008 09:43 AM

01+ rangers are live axle setups, no need for lockouts its all in the T-Case.

I would just leave it like that, no need for them really, less stuff to worry about too.

redranger4.0

01-23-2008 09:46 AM

live axle was 2000.5+ I like the live axle over the PVH as it always works.

lifted97ranger

01-23-2008 10:01 AM

like said above....

BUT, i would convert it to the '00 and older so you can install the AVM lockouts...

All times are GMT -6. The time now is 05:38 AM.