MISFIRE PROBLEMS
#1
MISFIRE PROBLEMS
i own a 2004 Ford Ranger XLT Fx4 Level II
i recently changed the harmonic balance and the crankshaft position sensor. the engine light came on and the codes were that there was a mifire in the 1st and 5th cylinder and it says that it was detected in the first 1000 revolutions. any ideas why this is happening, thanks
i recently changed the harmonic balance and the crankshaft position sensor. the engine light came on and the codes were that there was a mifire in the 1st and 5th cylinder and it says that it was detected in the first 1000 revolutions. any ideas why this is happening, thanks
#6
I'm having issues on my 05 3.0 w/#3 being the suspect cylinder only,after some research and help from members in here, the heads seem to have issues from04-06years with the exhaust valveseats being the problem causing loss of compression. I have changed plugs and wires only to have the issue return like batman.
Neither one of u guys posted what size engine you have.
Neither one of u guys posted what size engine you have.
#8
#10
oh ok so it the harmonic went bad wore into the sensor and it threw those codes, then you replaced everything adn still got the same codes or new ones?
ya ive had trouble with there sensors before too. the IAC sensor they had.
i would try to return it. but deff try to get a motorcraft one.
ya ive had trouble with there sensors before too. the IAC sensor they had.
i would try to return it. but deff try to get a motorcraft one.
Thread
Thread Starter
Forum
Replies
Last Post
bigsteff
General Technical & Electrical
0
03-18-2014 05:52 PM
JGod
General Ford Ranger Discussion
3
02-08-2014 06:35 AM